BATTERY COOLING DUCT REMOVAL

CAUTION / NOTICE / HINT

CAUTION:


  • B000ZMO

    This vehicle has contains high voltage circuits standardized with orange colored wiring and connectors, so follow the instructions in this manual to perform the procedures correctly.

    Click here

  • If the correct procedures are not followed according to the instructions in this manual, there is a danger of electric shock from the high voltage circuits.

  • B006JFB

    Be sure to wear insulating gloves when working on high voltage wiring or components.

  • If work is performed without wearing insulating gloves, there is a danger of electric shock.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE SERVICE PLUG GRIP (for EV)

    Click here

  3. REMOVE FC STACK SERVICE PLUG GRIP

    Click here

  4. REMOVE INVERTER COVER

    Click here

  5. REMOVE INVERTER TERMINAL COVER

    Click here

  6. CHECK TERMINAL VOLTAGE

    Click here

  7. INSTALL INVERTER TERMINAL COVER

    Click here

  8. REMOVE REAR SEAT ASSEMBLY

    Click here

  9. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  10. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  11. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  12. REMOVE NO. 1 EV BATTERY INTAKE DUCT

    CAUTION:

    Wear insulated gloves.

    Tech Tips

    If the message "See Dealer for Maintenance of Traction Battery Cooling System" is displayed on the multi-information display in the combination meter, perform inspection of the No. 1 EV battery intake duct after removal.

    Click here


    1. A01MHNC

      Remove the 3 clips and No. 1 EV battery intake duct from the battery cooling blower assembly and vehicle.

  13. REMOVE NO. 2 EV BATTERY UPPER COVER BRACKET

    CAUTION:

    Wear insulated gloves.


    1. A01MG80

      Remove the 2 nuts and No. 2 EV battery upper cover bracket from the No. 2 EV battery intake duct and EV battery.

  14. REMOVE NO. 2 EV BATTERY INTAKE DUCT

    CAUTION:

    Wear insulated gloves.


    1. A01MJAJ

      Remove the clip.

    2. Disengage the 2 claws and remove the No. 2 EV battery intake duct from the battery cooling blower assembly.