BATTERY BLOWER REMOVAL

CAUTION / NOTICE / HINT

CAUTION:


  • B000ZMO

    This vehicle has contains high voltage circuits standardized with orange colored wiring and connectors, so follow the instructions in this manual to perform the procedures correctly.

    Click here

  • If the correct procedures are not followed according to the instructions in this manual, there is a danger of electric shock from the high voltage circuits.

  • B006JFB

    Be sure to wear insulating gloves when working on high voltage wiring or components.

  • If work is performed without wearing insulating gloves, there is a danger of electric shock.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE SERVICE PLUG GRIP (for EV)

    Click here

  3. REMOVE FC STACK SERVICE PLUG GRIP

    Click here

  4. REMOVE INVERTER COVER

    Click here

  5. REMOVE INVERTER TERMINAL COVER

    Click here

  6. CHECK TERMINAL VOLTAGE

    Click here

  7. INSTALL INVERTER TERMINAL COVER

    Click here

  8. REMOVE EV BATTERY COOLING DUCT

    Click here

  9. REMOVE BATTERY COOLING BLOWER ASSEMBLY

    CAUTION:

    Wear insulated gloves.


    1. A01MG6Z

      Disconnect the battery cooling blower assembly connector.

    2. Remove the 3 nuts and battery cooling blower assembly from the EV battery.

      Note


      • Do not lift the battery cooling blower assembly using the wire harness.

      • Be sure not to touch the fan part of the battery cooling blower assembly.