Click here

REAR DOOR BELT MOULDING REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door belt moulding assembly removal/installation are shown below.

Table 1. Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here
Memorize steering angle neutral point Pre-crash safety system

Click here
Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • Fully open the rear door glass sub-assembly LH before proceeding with work.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. Click here

    REMOVE REAR DOOR FRAME GARNISH LH

    Click here

  4. Click here

    REMOVE REAR ARMREST ASSEMBLY LH

    Click here

  5. Click here

    REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

  6. Click here

    REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  7. Click here

    REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  8. Click here

    REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  9. Click here

    REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

  10. Click here

    REMOVE REAR DOOR GLASS RUN LH

    Click here

  11. Click here

    REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  12. Click here

    REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  13. Click here

    REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH


    1. B0025F5C01
      B00692L Protective Tape

      Put protective tape around the rear door belt moulding assembly LH.

    2. B0027VRC02
      B0069FO Remove in this Direction

      Using moulding remover D, detach the claw and remove the rear door belt moulding assembly LH as shown in the illustration.