POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the power window regulator motor assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Pre-crash safety system

Click here

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • Fully open the rear door glass sub-assembly LH before proceeding with work.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    for Type A:

    Click here

    for Type B:

    Click here

    B0069A2

    for Type C:

    Click here

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    B00693Q

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR DOOR FRAME GARNISH LH

    Click here

  4. REMOVE REAR ARMREST ASSEMBLY LH

    Click here

  5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  6. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  8. REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

  9. REMOVE REAR DOOR GLASS RUN LH

    Click here

  10. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  12. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

    Click here

  13. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    1. B0024GW

      w/ Jam Protection Function:

      Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly LH.

    2. B002837

      w/o Jam Protection Function:

      Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly LH.