COMBINATION METER

CAUTION / NOTICE / HINT

Tip:

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the combination meter removal/installation are shown below.

Table 1. Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	Pre-crash safety system	Click here

CAUTION:

w/ Airbag System:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

PROCEDURE

Click here
PRECAUTION (w/ Airbag System)

Note:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click here
Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Note:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
Click here
REMOVE STEERING WHEEL ASSEMBLY

Click here
Click here
REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Click here
Click here
REMOVE COMBINATION METER ASSEMBLY
1. Remove the 4 screws.
2. Disconnect the connector, detach the clamp and remove the combination meter assembly.

COMBINATION METER REMOVAL