DOWNHILL ASSIST CONTROL SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    Click here

  4. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)

    Click here

  5. REMOVE INTEGRATION PANEL SUB-ASSEMBLY (for Manual Cooler System)

    Click here

  6. REMOVE LOWER STEERING COLUMN COVER

    Click here

  7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  8. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  9. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  10. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  11. REMOVE LOWER INSTRUMENT COVER SUB-ASSEMBLY

    Click here

  12. REMOVE DOWNHILL ASSIST CONTROL SWITCH


    1. B00247AC01
      B0069FO Remove in this Direction

      Disconnect the downhill assist control switch connector.

    2. Detach the 2 claws and remove the downhill assist control switch from the lower instrument cover sub-assembly.