TIRE PRESSURE WARNING RECEIVER(for Double Cab) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tire pressure warning receiver removal/installation are shown below.

Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Pre-crash safety system

Click here

Tire pressure warning ECU and receiver

  • Register transmitter ID

  • Initialize tire pressure warning system

  • When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

  • Tire pressure warning function

for Registration: Click here

for Initialization: Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR SEAT ASSEMBLY


  4. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  5. REMOVE REAR DOOR SCUFF PLATE RH

    Click here

  6. REMOVE LOWER QUARTER TRIM PANEL LH

    Click here

  7. REMOVE LOWER QUARTER TRIM PANEL RH

    Click here

  8. REMOVE UPPER BACK PANEL GARNISH

    Click here

  9. REMOVE SEAT BELT ANCHOR COVER CAP

    Click here

  10. REMOVE QUARTER INSIDE TRIM BOARD LH

    Click here

  11. REMOVE QUARTER INSIDE TRIM BOARD RH

    Click here

  12. REMOVE BACK PANEL TRIM


    1. B00270AC01
      *A for Type A
      *B for Type B

      Remove the 5 clips and back panel trim.

  13. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

    Note


    • Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.

    • If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.


    1. B00285W

      Remove the bolt.

    2. Detach the 2 guides to remove the tire pressure warning ECU and receiver.

    3. Disconnect the connector from the tire pressure warning ECU and receiver.