STEERING COLUMN ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the steering column assembly removal/installation are shown below.

Necessary Procedures After Parts Removed / Installed / Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 40 minutes) Stop and start system

Click here

CAUTION:

Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing.

for Type A : Click here

for Type B : Click here

for Type C : Click here

B00291E

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  4. REMOVE STEERING COLUMN LOWER COVER


    1. B002662

      Remove the 3 bolts.

    2. B0028GLC01
      B0068AS Place Hands Here
      B0069FO Remove in this Direction (1)
      B0068NX Remove in this Direction (2)

      Detach the 2 claws and 6 guides to remove the steering column lower cover.

  5. REMOVE STEERING COLUMN UPPER COVER

    B0027WNC01
    B0069FO Remove in this Direction

    1. Detach the 2 claws and 2 guides to remove the steering column upper cover.

  6. REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY


    1. Disconnect the connectors from the combination switch assembly with spiral cable sub-assembly.

    2. B002962C01
      B0069FO Remove in this Direction

      Detach the 3 claws. Remove the combination switch assembly with spiral cable sub-assembly from the steering column sub-assembly.

  7. REMOVE NO. 1 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY

    Click here

  8. DISCONNECT STEERING SLIDING YOKE

    Click here

  9. REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY


    1. B00268C

      Remove the 3 bolts and No. 1 steering column hole cover sub-assembly.

  10. REMOVE STEERING COLUMN ASSEMBLY


    1. B0028WM

      Remove the bolt and 2 nuts, and then pull out the steering column assembly together with the steering sliding with coupling yoke.