ENGINE STOP AND START ECU REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine stop and start ECU removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Pre-crash safety system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here

Replacement of engine stop and start ECU

  1. Upload the number of starter operations

  2. Reset air conditioning information

  3. Learning of air conditioning information

  4. Clear the zero point calibration data

  5. Perform zero point calibration of the deceleration sensor

  6. Check electromagnetic oil pump

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

for Type A: Click here

for Type B: Click here

B00291E

PROCEDURE


  1. READ NUMBER OF STARTER OPERATIONS

    Click here

  2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  3. REMOVE NO. 2 AIR DUCT

    Click here

  4. REMOVE ENGINE STOP AND START ECU


    1. B0024QDC01
      *A for LHD
      *B for RHD

      Disconnect the 3 connectors and detach the clamp.

    2. Remove the 3 screws and engine stop and start ECU.