STARTER(for 2.0 kW Type) INSTALLATION

PROCEDURE

1. Click here

   INSTALL STARTER ASSEMBLY

   
   

   1. Temporarily install the starter assembly and ground cable with the bolt.

   2. Temporarily install the clutch flexible hose bracket with the bolt.

   3. Tighten the 2 bolts.

      68 N*m

      693 kgf*cm

      50 ft.*lbf

   4. Connect the starter wire with the nut.

      9.8 N*m

      100 kgf*cm

      87 in.*lbf

   5. Connect the starter connector.

   6. Install the starter terminal cap.

2. Click here

   CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

   Click here

3. Click here

   INSTALL FRONT FENDER SEAL LH

   
   

   1. for 4WD and Pre-Runner:

      Install the front fender seal LH with new 6 clips.

   2. for 2WD:

      Install the front fender seal LH with new 5 clips.

4. Click here

   INSTALL NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)

   Click here

5. Click here

   INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)

   Click here

6. Click here

   CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here