Click here

ECD SYSTEM(w/ Urea SCR System), Diagnostic DTC:P00BB

Click here
Click here
DTC Code DTC Name
P00BB Fuel Injector Insufficient Flow - Forced Limited Power
*1 Fuel Supply Pump Assembly *2 Pressurized Fuel Filter *3 Fuel Filter Element Assembly *4 Fuel Tank *5 to Exhaust Fuel Addition Injector Assembly *6 to Common Rail Assembly *7 from Injector Assembly - - High Pressure Fuel Feed Fuel Suction Fuel Return Fuel
Click here

DESCRIPTION

In order to detect blockages in the pressurized fuel filter, the ECM determines if the fuel pressure of the common rail has deviated from the target value every 5000 km. If the average value of the judgment values recorded every 5000 km exceeds the threshold, a blockage is determined to be occurring in the pressurized fuel filter and a DTC is stored.

Also, at the same time, a message is displayed on the multi-information display and engine output is limited. The message on the multi-information display disappears after clearing the DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P00BB Fuel Injector Insufficient Flow - Forced Limited Power The average judgment value of the fuel pressure deviation state every 5000 km exceeds the threshold (1 trip detection logic).

  • Fuel filter cap with element

  • Fuel filter element assembly

-*

*: The multi-information display does illuminate.

 DTC stored
Table 1. Related Data List
DTC No. Data List
P00BB

  • Common Rail Pressure

  • Target Common Rail Pressure
Click here

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P00BB Idling for 1 second or more
Click here

CAUTION / NOTICE / HINT

Tip:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

Click here

PROCEDURE


  1. Click here

    CHECK DTC OUTPUT


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Enter the following menus: Powertrain / Engine / Trouble Codes.

    4. Read the DTCs.


      1. Powertrain > Engine > Trouble Codes


      Result
      DTC P00BB is output.
      Tip:

      When DTC P00BB is output, the fuel filter cap with element needs to be replaced. In order to inspect the fuel filter element assembly for blockages, do not perform replacement at this stage.

      Result
      Proceed to
      NEXT

  2. Click here

    INSPECT FUEL FILTER ELEMENT ASSEMBLY


    1. Disconnect the clogging switch connector from the fuel filter element assembly.

    2. Start the engine and warm it up.

    3. Connect a circuit tester to the clogging switch.

    4. Check that the clogging switch does not turn OFF (10 kΩ or higher) when revving the engine up from idling.

      Tip:

      If the clogging switch turns OFF, it can be determined that the fuel filter element assembly is becoming clogged.

      OK
      The clogging switch does not change from ON (below 1Ω) when revving the engine up from idling.
      Result
      Proceed to
      OK
      NG

  3. Click here

    REPLACE FUEL FILTER CAP WITH ELEMENT


    1. Replace the fuel filter cap with element.

      Click here

      Result
      Proceed to
      NEXT

  4. Click here

    BLEED AIR FROM FUEL SYSTEM


    1. Bleed the air from the fuel system.

      Click here

      Result
      Proceed to
      NEXT

  5. Click here

    CLEAR DTC


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Clear the DTCs.


      1. Powertrain > Engine > Clear DTCs


      Tip:

      Clearing the DTCs turns off the message in the multi-information display.

      Result
      Proceed to
      NEXT

    • NEXT

      END

  6. Click here

    REPLACE FUEL FILTER ELEMENT ASSEMBLY


    1. Replace the fuel filter element assembly.

      Click here

      Result
      Proceed to
      NEXT