Click here

ECD SYSTEM(w/o EGR Cooler), Diagnostic DTC:P0606, P060A, P060B, P060D, P1607

Click here
Click here
DTC Code DTC Name
P0606 ECM / PCM Processor
P060A Internal Control Module Monitoring Processor Performance
P060B Internal Control Module A/D Processing Performance
P060D Internal Control Module Accelerator Pedal Position Performance
P1607 Cruise Control Input Processor
Click here

DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0606 ECM / PCM Processor ECM internal error continues for 1 second (1 trip detection logic). ECM Comes on DTC stored
P060A Internal Control Module Monitoring Processor Performance ECM internal error continues for 1 second (1 trip detection logic). ECM Comes on DTC stored
P060B Internal Control Module A/D Processing Performance ECM internal error continues for 1 second (1 trip detection logic). ECM Comes on DTC stored
P060D Internal Control Module Accelerator Pedal Position Performance

Either of the following conditions is met (1 trip detection logic):


  • There is an ECM main CPU error.

  • There is an ECM sub CPU error.

 ECM Comes on DTC stored
P1607 Cruise Control Input Processor ECM internal error continues for 1 second (1 trip detection logic). ECM Comes on DTC stored
Click here

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P0606 Ignition switch ON for 1 second or more
P060A
P060B
P060D
P1607
Click here

CAUTION / NOTICE / HINT

Note:

After replacing the ECM, the new ECM needs registration (Click here ) and initialization (Click here).

Tip:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

Click here

PROCEDURE


  1. Click here

    CHECK WHETHER DTC OUTPUT RECURS


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs.


      1. Powertrain > Engine and ECT > Clear DTCs


    4. Turn the ignition switch off for 30 seconds or more.

    5. Turn the ignition switch to ON for 1 second or more.

    6. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    7. Read the DTCs.


      1. Powertrain > Engine and ECT > Trouble Codes


      Result
      Result Proceed to
      DTC P0606, P060A, P060B, P060D and/or P1607 is output A
      No DTC is output B

  2. Click here

    REPLACE ECM


    1. Replace the ECM.

      Click here

      Result
      Proceed to
      NEXT

  3. Click here

    CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the GTS to the DLC3.

    2. Clear the DTCs.


      1. Powertrain > Engine and ECT > Clear DTCs


    3. Turn the ignition switch off for 30 seconds or more.

    4. Turn the ignition switch to ON for 1 second.

    5. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    6. Confirm that the DTC is not output again.


      1. Powertrain > Engine and ECT > Trouble Codes


      Result
      Proceed to
      NEXT

    • NEXT

      END