FRONT DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY LH

   
   

   1. 

      Install in this Direction

      Attach the claw to install a new front door belt moulding assembly LH.

   2. Remove the protective tape.

2. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

   Tech Tips

   Use the same procedure described for the RH side.

   Click here

3. INSTALL FRONT DOOR GLASS RUN LH

   Tech Tips

   Use the same procedure described for the RH side.

   Click here

4. INSTALL FRONT DOOR SERVICE HOLE COVER LH

   Tech Tips

   Use the same procedure described for the RH side.

   Click here

5. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

   Click here

6. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

   Tech Tips

   Use the same procedure described for the RH side.

   Click here

7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

   Tech Tips

   Use the same procedure described for the RH side.

   Click here

8. INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

   Click here

9. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

   Click here

10. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

11. INSTALL FRONT ARMREST ASSEMBLY LH

    Tech Tips

    Use the same procedure described for the RH side.

    Click here

12. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Tech Tips

    Use the same procedure described for the RH side.

    Click here

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

14. CHECK SRS WARNING LIGHT

    Click here