HAZARD WARNING SWITCH INSTALLATION

PROCEDURE

1. INSTALL CLOCK ASSEMBLY (Hazard Warning Switch)

   
   

   1. Install the clock assembly with the screw.

   2. Connect the connector.

2. INSTALL NO. 2 HEATER TO REGISTER DUCT (w/ Navigation System)

   Click here

3. INSTALL NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (w/ Navigation System)

   Click here

4. INSTALL NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY (w/ Navigation System)

   Click here

5. INSTALL DEFROSTER NOZZLE ASSEMBLY (w/ Navigation System)

   Click here

6. INSTALL UPPER INSTRUMENT PANEL

   Click here

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

8. PERFORM DIAGNOSTIC SYSTEM CHECK

   Click here

9. CHECK SRS WARNING LIGHT

   Click here