KNEE AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   
   

   1. Check that the engine switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. 

      *1	Connector Lock

      Connect the airbag connector and push in the connector lock.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

   4. Attach the 2 hooks to set the lower No. 1 instrument panel airbag assembly.

   5. Install the 4 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

4. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH

   Click here

5. INSTALL REAR CONSOLE ARMREST ASSEMBLY

   Click here

6. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

7. INSTALL INSTRUMENT SIDE PANEL LH

   Click here

8. INSTALL COWL SIDE TRIM BOARD LH

   Click here

9. INSTALL DOOR SCUFF PLATE ASSEMBLY LH

   Click here

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

11. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

12. CHECK SRS WARNING LIGHT

    Click here