COMBINATION METER INSTALLATION

CAUTION / NOTICE / HINT

Note

When replacing the combination meter assembly, make sure to replace it with a new one.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL COMBINATION METER ASSEMBLY


    1. B00592PC05
      *a Screw

      Connect the connectors and attach the clamp.

    2. Install the combination meter assembly with the 4 screws.

  2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  3. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    Click here

  4. INSTALL MULTI-DISPLAY ASSEMBLY WITH BRACKET

    Click here

  5. INSTALL INSTRUMENT PANEL FINISH PLATE

    Click here

  6. INSTALL NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  7. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

  8. INSTALL NO. 1 SWITCH HOLE BASE

    Click here

  9. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  10. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  11. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  12. INSTALL INSTRUMENT SIDE PANEL LH

    Click here

  13. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH

    Click here

  14. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH

    Click here

  15. INSTALL UPPER REAR CONSOLE PANEL

    Click here

  16. INSTALL CONSOLE ARMREST ASSEMBLY

    Click here

  17. INSTALL COWL SIDE TRIM BOARD RH (for RHD)

    Click here

  18. INSTALL DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

    Click here

  19. ENABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column)


    1. Restore the autoaway/return function setting to the previous condition by changing the customize parameter.

      Click here