REMOTE TOUCH INSTALLATION

PROCEDURE

1. INSTALL REMOTE OPERATION CONTROLLER ASSEMBLY

   
   

   1. Install the remote operation controller assembly with the 4 bolts.

2. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY

   Click here

3. INSTALL UPPER REAR CONSOLE PANEL

   Click here

4. INSTALL CONSOLE ARMREST ASSEMBLY

   Click here

5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

   Click here

6. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

   Click here

7. INSTALL NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

8. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

9. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

10. INSTALL NO. 1 SWITCH HOLE BASE

    Click here

11. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

12. INSTALL INSTRUMENT SIDE PANEL LH

    Click here

13. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

14. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH

    Click here

15. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH

    Click here

16. INSTALL COWL SIDE TRIM BOARD RH (for RHD)

    Click here

17. INSTALL DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

    Click here

18. INSTALL MULTI-DISPLAY ASSEMBLY WITH BRACKET

    Click here

19. INSTALL INSTRUMENT PANEL FINISH PLATE

    Click here

20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here