PROCEDURE
INSTALL RADIO RECEIVER ASSEMBLY
INSTALL NAVIGATION ECU
INSTALL NO. 1 RADIO BRACKET
w/ Navigation System
Install the No. 1 radio bracket with the 3 screws.
w/o Navigation System
Install the No. 1 radio bracket with the 3 screws.
INSTALL NO. 2 RADIO BRACKET
w/ Navigation System
Install the No. 2 radio bracket with the 3 screws.
w/o Navigation System
Install the No. 2 radio bracket with the 3 screws.
INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET
Connect each connector.
Attach the 4 clips to temporarily install the radio receiver assembly with bracket.
Install the radio receiver assembly with bracket with the 4 bolts.
INSTALL AIR CONDITIONING CONTROL ASSEMBLY
INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
INSTALL NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
INSTALL NO. 1 SWITCH HOLE BASE
INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
INSTALL INSTRUMENT SIDE PANEL LH
INSTALL INSTRUMENT SIDE PANEL RH
INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH
INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH
INSTALL UPPER REAR CONSOLE PANEL
INSTALL CONSOLE ARMREST ASSEMBLY
INSTALL COWL SIDE TRIM BOARD RH (for RHD)
INSTALL DOOR SCUFF PLATE ASSEMBLY RH (for RHD)
INSTALL MULTI-DISPLAY ASSEMBLY WITH BRACKET
INSTALL INSTRUMENT PANEL FINISH PLATE
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
CHECK SRS WARNING LIGHT