HEATED OXYGEN SENSOR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL HEATED OXYGEN SENSOR

   Tech Tips

   w/ Canister Pump Module:

   Perform "Inspection After Repairs" after replacing the heated oxygen sensor.

   Click here

   
   
   1. 

      *a	Torque Wrench Fulcrum Length

      Using SST, install the heated oxygen sensor.

      SST

      09224-00011

      Torque
      Specified tightening torque
      44 N*m (449 kgf*cm, 32 ft.*lbf)

      Note

      Replace with a new part if it is dropped or if it receives a strong impact.

      Tech Tips

      
      

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 37.7 N*m (384 kgf*cm, 28 ft.*lbf)

2. INSTALL FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY

   
   

   1. Install a new gasket to the front exhaust pipe sub-assembly.

   2. Install a new gasket to the front No. 2 exhaust pipe sub-assembly.

   3. Install the front No. 2 exhaust pipe sub-assembly with the 4 bolts and 2 new nuts.

      Torque:

      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

   4. Attach the 2 wire harness clamps to connect the wire harness to the wire harness clamp bracket.

   5. Connect the heated oxygen sensor connector.

3. INSPECT FOR EXHAUST GAS LEAK

   Click here