SHIFT PADDLE SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with the battery connected and the engine switch on (IG).

  • Do not rotate the spiral cable when the following conditions are met: 1) The steering wheel is removed, 2) the battery is connected, and 3) the engine switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

  • Do not remove the steering sensor from the spiral cable.

PROCEDURE


  1. INSTALL NO. 2 SWITCH WIRE (w/o Lane Departure Alert System)

    Tech Tips

    There is no need to remove this unless the No. 2 switch wire is replaced.


    1. B0059IC

      Engage the 2 guides to install the No. 2 switch wire to the steering wheel assembly.

    2. B0057Z6

      Engage the No. 2 switch wire connector clamp to the steering wheel assembly.

  2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/o Lane Departure Alert System)


    1. Connect the 2 shift paddle switch (transmission shift switch assembly) connectors to install the 2 shift paddle switches (transmission shift switch assemblies) to the No. 1 switch wire.

    2. Engage the 5 guides to install the 2 shift paddle switches (transmission shift switch assemblies) with No. 1 switch wire to the steering wheel assembly.

    3. Install the 2 shift paddle switches (transmission shift switch assemblies) to the steering wheel assembly with 4 new screws.

    4. Connect the No. 1 switch wire connector.

  3. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Lane Departure Alert System)


    1. Engage the 6 guides to install the 2 shift paddle switches (transmission shift switch assemblies) with No. 1 switch wire to the steering wheel assembly.

    2. Connect the 2 shift paddle switch (transmission shift switch assembly) connectors to install the 2 shift paddle switches (transmission shift switch assemblies) to the No. 1 switch wire.

    3. Install the 2 shift paddle switches (transmission shift switch assemblies) to the steering wheel assembly with 4 new screws.

    4. Connect the No. 1 switch wire connector.

    5. Engage the guide to connect the No. 1 switch wire to the steering wheel assembly.

  4. INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Lane Departure Alert System)

    Click here

  5. INSTALL CRUISE CONTROL MAIN SWITCH (w/ Lane Departure Alert System)

    Click here

  6. INSTALL STEERING WHEEL ASSEMBLY

    Click here