CAUTION / NOTICE / HINT
Note
Do not replace the spiral with sensor cable sub-assembly with the battery connected and the engine switch on (IG).
Do not rotate the spiral with sensor cable sub-assembly when the following conditions are met: 1) The steering wheel is removed, 2) the battery is connected,and 3) the engine switch is on (IG).
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
PROCEDURE
INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY
w/o Steering Wheel Vibration:
w/ Steering Wheel Vibration:
INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
INSTALL STEERING SHAKE DAMPER
Install the 2 screws and steering shake damper to the steering wheel assembly.
INSTALL STEERING PAD SWITCH ASSEMBLY
INSTALL CRUISE CONTROL MAIN SWITCH
PLACE FRONT WHEELS FACING STRAIGHT AHEAD
ADJUST SPIRAL CABLE
INSTALL STEERING WHEEL ASSEMBLY
Align the matchmarks on the steering wheel assembly and steering main shaft.
Install the steering wheel assembly set nut.
Connect the connector.
Connect each connector to the spiral cable with sensor sub-assembly.
INSTALL STEERING PAD