CHASSIS GENERAL MAINTENANCE

Click here

PROCEDURE

1. Click here

   INSPECT STEERING LINKAGE AND GEAR HOUSING

   
   

   1. Check the steering wheel free play.

      Click here

   2. Check the steering linkage for looseness or damage.

      
      

      1. Check that the tie rod ends do not have any play.

      2. Check that the dust seals and boots are not damaged.

      3. Check that the boot clamps are not loose.

      4. Check that the steering gear housing is not damaged.

2. Click here

   INSPECT BALL JOINTS AND DUST COVERS

   
   

   1. Inspect the ball joints for excessive looseness.

      
      

      1. Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires.

      2. Lower the vehicle until the front coil spring has about half its ordinary load. Place stands under the vehicle for safety.

      3. Check that the front wheels are pointing straight ahead. Use wheel chocks on all 4 wheels.

      4. Using a lever, pry up the end of the lower arm. Check the amount of play.

         Maximum Ball Joint Vertical Play
         0 mm (0 in.)

         If there is any play, replace the ball joint.

   2. Check the dust cover for damage.

3. Click here

   INSPECT DRIVE SHAFT BOOTS

   
   

   1. Check the drive shaft boots for loose clamps, cracks, grease leaks, kinks or damage.

4. Click here

   INSPECT AUTOMATIC TRANSMISSION

   
   

   1. Visually check the transmission for fluid leaks. If fluid is leaking, find the cause and repair it.

5. Click here

   INSPECT DIFFERENTIAL

   
   

   1. Visually check the rear differential for oil leaks. If oil is leaking, find the cause and repair it.

6. Click here

   INSPECT FRONT AND REAR SUSPENSION

   
   

   1. Check the front and rear suspension.

      for Front Suspension:Click here

      for Rear Suspension:Click here

7. Click here

   TIGHTEN PROPELLER SHAFT BOLT

   
   

   1. Tighten the propeller shaft bolts.

      Click here