HOOD LOCK CONTROL CABLE ASSEMBLY INSTALLATION

PROCEDURE

1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

   
   

   1. Pass the hood lock control cable assembly into the engine compartment.

   2. Engage the grommet.

   3. Engage the 4 clamps to install the hood lock control cable assembly.

2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   
   

   1. Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.

3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

5. INSTALL HOOD LOCK ASSEMBLY

   
   

   1. Apply MP grease to the sliding areas of the hood lock assembly.

   2. Connect the hood lock control cable assembly to the hood lock assembly.

   3. Install the hood lock assembly with the 2 bolts and hood lock bolt.

      Torque:

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Tech Tips

      The hood lock nut cap is a non-reusable part. Be sure to install it after performing the Inspect Hood Sub-assembly and Adjust Hood Sub-assembly steps.

   4. w/ Engine Hood Courtesy Switch:

      
      

      1. Connect the connector.

6. INSTALL RADIATOR SUPPORT OPENING COVER

   Click here

7. INSTALL FRONT FENDER LINER LH (for LHD)

   Tech Tips

   Use the same procedure as for the RH side.

   Click here

8. INSTALL FRONT FENDER LINER RH (for RHD)

   Click here

9. INSTALL FRONT WHEEL LH (for LHD)

   Click here

10. INSTALL FRONT WHEEL RH (for RHD)

    Click here

11. ADJUST HOOD SUB-ASSEMBLY

    Click here