PCV VALVE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during PCV valve (ventilation valve sub-assembly) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of throttle body assembly

  • Cleaning the deposits from the throttle body assembly

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here w/ Canister Pump Module

Click here w/o Canister Pump Module

PROCEDURE


  1. REMOVE INTAKE MANIFOLD

    Click here

  2. DISCONNECT VENTILATION HOSE


    1. A01RHBD

      Slide the clip and disconnect the ventilation hose from the PCV valve (ventilation valve sub-assembly).

  3. REMOVE PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)


    1. A01RJDU

      Using a 22 mm ball joint lock nut wrench, remove the PCV valve (ventilation valve sub-assembly) from the No. 1 ventilation case.