AUDIO AND VISUAL SYSTEM(for 10.3 Inch Display) CD/DVD Sound Skips

CAUTION / NOTICE / HINT

Note

When replacing the radio receiver assembly, always replace it with a new one.

If a radio receiver assembly which was installed to another vehicle is used, the following may occur:


  • A communication malfunction DTC may be stored.

  • The radio receiver assembly may not operate normally.

Tech Tips

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click here

PROCEDURE


  1. CHECK DISC


    1. B002KZV

      Check that the disc is not deformed or cracked.

      OK
      No deformation or cracks on the disc
      Result
      Proceed to
      OK
      NG

    NG

    END (DISC IS DEFECTIVE)

    OK

  2. CHECK DISC


    1. B002IY9

      Check the disc.

      OK
      The disc is clean.

      Note

      Do not use a conventional record cleaner or anti-static preservative.

      Tech Tips

      If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

      Result
      Proceed to
      OK
      NG

    NG

    CLEAN DISC

    OK

  3. REPLACE DISC AND RECHECK


    1. Replace the disc with a known good one and check that the malfunction disappears.

      OK
      Malfunction disappears.
      Result
      Proceed to
      OK
      NG

    OK

    END (DISC IS DEFECTIVE)

    NG

  4. CHECK RADIO RECEIVER ASSEMBLY


    1. Check the radio receiver assembly installation condition.


      1. Check that the radio receiver assembly is properly installed.

        OK
        The radio receiver assembly is properly installed.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE RADIO RECEIVER ASSEMBLY Click here

    NG

    REINSTALL RADIO RECEIVER ASSEMBLY Click here