PROCEDURE
REMOVE DECK BOARD ASSEMBLY
REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY
REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)
REMOVE DECK FLOOR BOX LH (w/ Spare Tire)
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE INSTRUMENT PANEL FINISH PLATE
REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET
REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for RHD)
REMOVE COWL SIDE TRIM BOARD RH (for RHD)
REMOVE CONSOLE ARMREST ASSEMBLY
REMOVE UPPER REAR CONSOLE PANEL
REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH
REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH
REMOVE INSTRUMENT SIDE PANEL RH
REMOVE INSTRUMENT SIDE PANEL LH
REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
REMOVE NO. 1 SWITCH HOLE BASE
REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
REMOVE AIR CONDITIONING CONTROL ASSEMBLY
REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
Remove the 2 bolts.
Pull the radio receiver assembly with bracket toward the rear of the vehicle and disengage the 4 clips.
Disconnect each connector and remove the radio receiver assembly with bracket.
REMOVE NO. 1 RADIO BRACKET
w/ Navigation System
Remove the 5 screws and No. 1 radio bracket.
w/o Navigation System
Remove the 3 screws and No. 1 radio bracket.
REMOVE NO. 2 RADIO BRACKET
w/ Navigation System
Remove the 5 screws and No. 2 radio bracket.
w/ Navigation System
Remove the 3 screws and No. 2 radio bracket.
REMOVE NAVIGATION ECU
REMOVE RADIO RECEIVER ASSEMBLY