HEATED OXYGEN SENSOR(for Bank 2) INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR


    1. A0028J6C01
      *a Torque Wrench Fulcrum Length

      Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.

      SST
      09224-00012
      Torque:
      Specified tightening torque
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

        37.7 N*m (384 kgf*cm, 28 ft.*lbf)

  2. INSTALL FRONT EXHAUST PIPE ASSEMBLY

    Click here

  3. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side)

    Click here

  4. INSTALL FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY

    Click here

  5. INSPECT FOR EXHAUST GAS LEAK

    Click here

  6. INSTALL NO. 2 ENGINE UNDER COVER

    Click here

  7. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  8. INSTALL FRONT FLOOR COVER LH

    Click here