HEATED OXYGEN SENSOR(for Bank 1) INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR (for AWD)


    1. A0027O6C01
      *a Torque Wrench Fulcrum Length

      Using SST, install the heated oxygen sensor to the front No. 3 exhaust pipe sub-assembly.

      SST
      09224-00012
      Torque:
      Specified tightening torque
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

        37.7 N*m (384 kgf*cm, 28 ft.*lbf)

    2. A00281CC01
      *1 Wire Harness Clamp Bracket
      *a Left of Vehicle
      *b 180°

      Install the wire harness clamp bracket to the heated oxygen sensor.

      Tech Tips

      Make sure the direction of the wire harness clamp bracket is as shown in the illustration.

  2. INSTALL FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY (for AWD)

    Click here

  3. INSTALL HEATED OXYGEN SENSOR (for 2WD)


    1. A002BO8C01
      *a Torque Wrench Fulcrum Length

      Using SST, install the heated oxygen sensor to the front No. 3 exhaust pipe sub-assembly.

      SST
      09224-00012
      Torque:
      Specified tightening torque
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

        37.7 N*m (384 kgf*cm, 28 ft.*lbf)

    2. A0029S6C01
      *1 Wire Harness Clamp Bracket
      *a Left of Vehicle
      *b 180°

      Install the wire harness clamp bracket to the heated oxygen sensor.

      Tech Tips

      Make sure the direction of the wire harness clamp bracket is as shown in the illustration.

    3. Engage the 3 wire harness clamps.

    4. Connect the heated oxygen sensor connector.

  4. INSPECT FOR EXHAUST GAS LEAK

    Click here

  5. INSTALL NO. 2 ENGINE UNDER COVER

    Click here

  6. INSTALL FRONT FLOOR COVER LH

    Click here