INJECTOR DRIVER INSTALLATION

PROCEDURE

1. INSTALL INJECTOR DRIVER

   Note

   Be careful not to drop or strike the injector driver.

   
   

   1. Install the injector driver to the intake manifold with the 2 bolts and 2 nuts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

   2. 

      *a	Lock Lever
      *b	Connector (with Lock)

      Connect the 2 injector driver connectors.

   3. Connect the connector (with lock) to the injector driver and move the lock lever as shown in the illustration to engage the lock.

      Note

      Securely connect the connector (with lock) to the injector driver and engage the lock lever.

2. INSTALL AIR CLEANER HOSE ASSEMBLY

   Click here

3. INSTALL AIR CLEANER CAP WITH NO. 2 AIR CLEANER HOSE

   Click here

4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

   Click here

5. INSTALL INLET NO. 1 AIR CLEANER

   Click here

6. INSTALL COOL AIR INTAKE DUCT SEAL

   Click here

7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

8. INSTALL BATTERY SERVICE HOLE COVER LH

   Click here