WATER PUMP WITH MOTOR INSTALLATION

PROCEDURE


  1. INSTALL HV WATER PUMP BRACKET SUB-ASSEMBLY

    Tech Tips

    Perform this procedure only when replacement of the HV water pump bracket sub-assembly is necessary.


    1. A00216QC01
      *a Claw

      Engage the claw to the body and install the HV water pump bracket sub-assembly with the 2 bolts.

      Torque:
      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }

    2. Engage the 3 clamps to the HV water pump bracket sub-assembly.

    3. Install the air cleaner assembly with No. 2 air cleaner hose.

      Click here

  2. INSTALL INVERTER WATER PUMP ASSEMBLY


    1. Install the inverter water pump assembly to the HV water pump bracket sub-assembly with the 3 bolts.

      Torque:
      6.1 N*m  { 62 kgf*cm, 54 in.*lbf }

    2. Connect the inverter water pump assembly connector.

    3. A0022N5C01
      *1 Inlet Hybrid Water Pump Hose
      *2 Outlet No. 1 Hybrid Water Pump Hose
      *a Upper Side
      *b Front Side
      *c LH Side

      Connect the inlet hybrid water pump hose and outlet No. 1 hybrid water pump hose, and slide the 2 clips to secure them.

      Note

      Do not remove the pieces of cloth from the pipes and disconnected hoses until installation to prevent foreign matter from entering the inverter water pump and cooling system.

      Tech Tips

      Make sure that the clip is positioned as shown in the illustration.

  3. INSTALL INLET NO. 1 AIR CLEANER

    Click here

  4. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  5. ADD COOLANT (for Inverter)

    Click here

  6. INSPECT FOR COOLANT LEAK (for Inverter)

    Click here

  7. INSTALL ENGINE UNDER COVER

    Click here