REAR DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. INSTALL REAR DOOR BELT MOULDING ASSEMBLY


    1. B003VKM

      Engage the 4 claws and 2 guides to install the rear door belt moulding assembly as shown in the illustration.

  3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  4. INSTALL REAR DOOR QUARTER WINDOW GLASS

    Click here

  5. INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

  6. INSTALL REAR DOOR GLASS RUN

    Click here

  7. CONNECT REAR DOOR WEATHERSTRIP

    Click here

  8. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  9. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

  10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  11. INSTALL REAR DOOR NO. 1 STIFFENER CUSHION

    Click here

  12. INSTALL REAR DOOR NO. 3 ARMREST COVER

    Click here

  13. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  14. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  16. INSPECT POWER WINDOW OPERATION

    Click here