FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE SEAT BELT ANCHOR COVER CAP (for Manual Seat)

   
   

   1. Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.

   2. Operate the vertical adjusting handle and move the front seat assembly to the uppermost position.

   3. 

      Using a moulding remover, disengage the claw.

   4. 

      Using a moulding remover, disengage the 3 claws and guide, and remove the seat belt anchor cover cap.

2. REMOVE SEAT BELT ANCHOR COVER CAP (for Power Seat)

   
   

   1. Operate the slide and vertical power seat switch knob and move the front seat assembly to the foremost position.

   2. Operate the slide and vertical power seat switch knob and move the front seat assembly to the uppermost position.

   3. 

      *a	Protective Tape

      Using a screwdriver, disengage the claw (A).

      Tech Tips

      Tape the screwdriver tip before use.

   4. Pull the seat belt anchor cover cap as shown in the illustration to disengage the 3 claws (B) and 2 guides, and remove the seat belt anchor cover cap.

3. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY (for Manual Seat)

   
   

   1. 

      Remove the bolt to disconnect the anchor of the front seat outer belt assembly.

4. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY (for Power Seat)

   

   
   

   1. Remove the bolt to disconnect the anchor of the front seat outer belt assembly.

5. PRECAUTION

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

6. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

7. REMOVE FRONT DOOR SCUFF PLATE

   Click here

8. REMOVE REAR SEAT CUSHION ASSEMBLY

   Click here

9. REMOVE REAR SEAT CUSHION LOCK HOOK

   Click here

10. REMOVE REAR DOOR SCUFF PLATE

    Click here

11. REMOVE LOWER CENTER PILLAR GARNISH

    Click here

12. REMOVE CENTER PILLER GARNISH ASSEMBLY

    Click here

13. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

    

    
    

    1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. 

       *a	Protective Tape
       *b	Locking Button
       *c	Release

       Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector as shown in the illustration.

       Tech Tips

       Tape the screwdriver tip before use.

    3. Disconnect the connector.

    4. 

       Remove the 2 bolts and front seat outer belt assembly.

14. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

    
    

    1. 

       Remove the 2 bolts.

    2. Disengage the guide to remove the front shoulder belt anchor adjuster assembly.