CRUISE CONTROL SYSTEM(for 2GR-FSE, 4GR-FSE) Cruise Main Indicator Light Circuit

DESCRIPTION

• The ECM turns on the cruise control indicator by sending indicator output demand signals to the combination meter assembly using CAN communication.

• The cruise control indicator illuminates when the cruise control system has been turned on using the cruise control switch (ON/OFF button). If a malfunction is detected, the cruise control indicator goes off and a warning message is displayed.

• The cruise control indicator circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

PROCEDURE

1. PERFORM ACTIVE TEST USING GTS (INDICAT. LAMP CRUISE)

   
   

   1. Connect the GTS to the DLC3.

   2. Turn the engine switch on (IG).

   3. Turn the GTS on.

   4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

   5. Perform "Active Test" according to the display on GTS.

      
      Body Electrical > Combination Meter > Active Test

      Tester Display	Measurement Item	Control Range	Diagnostic Note
      Indicat. Lamp Cruise	Cruise control indicator	ON or OFF	for F SPORT models
      Meter Display 1	Multi-information display	OFF or All	except F SPORT models

      
      Body Electrical > Combination Meter > Active Test

      Tester Display
      Indicat. Lamp Cruise

      
      Body Electrical > Combination Meter > Active Test

      Tester Display
      Meter Display 1

      OK
      for F SPORT models
      The cruise control indicator goes on or off.
      except F SPORT models
      The multi-information display turns on or off.

      Result
      Proceed to OK NG

   
   

   NG

   GO TO METER / GAUGE SYSTEM Click here

   OK

2. READ VALUE USING GTS (CCS INDICATOR M-CPU)

   
   

   1. Enter the following menus: Powertrain / Cruise Control / Data List.

   2. Read the Data List according to the display on the GTS.

      
      Powertrain > Cruise Control > Data List

      Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
      CCS Indicator M-CPU	Cruise control indicator signal (Main-CPU)	ON or OFF	Each time cruise control switch (ON/OFF button) is pushed, ON or OFF changes	-

      
      Powertrain > Cruise Control > Data List

      Tester Display
      CCS Indicator M-CPU

      OK
      When the cruise control switch (ON/OFF button) is operated, the display changes as shown above.

      Result
      Proceed to OK NG

   
   

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

   NG

   REPLACE ECM for 2GR-FSE: Click here for 4GR-FSE: Click here