CAUTION / NOTICE / HINT
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
PROCEDURE
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE ENGINE ROOM ECU COVER
Note
Remove all water on and around the engine room ECU cover.
Perform the inspection indoors to avoid rain.
Be sure to prevent water intrusion to the ECM (connectors and screw parts).
Remove the 3 bolts and engine room ECU cover.
DISCONNECT WIRE HARNESS
Disconnect the 2 engine wire harness connectors from the connector holder.
Disengage the claw and disconnect the connector from the connector holder.
Using a screwdriver, disengage the claw.
Disconnect the connector holder from the engine room ECU box.
Disconnect the 6 ECM connectors.
REMOVE ECM
Remove the 2 nuts and ECM from the engine room ECU box.
Note
If the ECM has been struck or dropped, replace it.
REMOVE NO. 1 ECM BRACKET
Remove the 2 screws and No. 1 ECM bracket from the ECM.
REMOVE NO.2 ECM BRACKET
Remove the 2 screws and No. 2 ECM bracket from the ECM.