DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL V-RIBBED BELT

    Tech Tips

    When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt.


    1. B003WEKC02
      *1 Water Pump Assembly
      *2 No. 2 Idler Pulley Sub-assembly
      *3 Generator Assembly
      *4 Crankshaft Pulley
      *5 V-ribbed Belt Tensioner Assembly
      *6 Compressor and Magnetic Clutch Assembly

      Install the V-ribbed belt.

      Note


      • Make sure to put the backside of the V-ribbed belt on the V-ribbed belt tensioner assembly pulley and No. 2 idler pulley sub-assembly.

      • Check that the V-ribbed belt is properly set to each pulley.

    2. Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.

    3. B003V95C02
      *a Correct
      *b Incorrect

      After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand.

  2. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here

  3. INSTALL INLET NO. 1 AIR CLEANER

    Click here

  4. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here