CAUTION / NOTICE / HINT
Tech Tips
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
PROCEDURE
INSTALL FRONT BUMPER ASSEMBLY
Move the front bumper assembly into position and engage the 12 guides and 2 claws as shown in the illustration.
*a | Push |
w/ Headlight Cleaner System:
Engage the claw to connect the washer hose to the headlight cleaner hose as shown in the illustration.
Pull back the side of the front bumper assembly and connect each connector.
Note
Do not apply excessive force when pulling back the front bumper assembly.
Engage the 2 claws as shown in the illustration.
Tech Tips
Use the same procedure for the RH side and LH side.
w/ Lexus Safety System+:
Connect the connector.
Install the 2 clips.
Install the 3 bolts.
Install the 10 screws.
*1 | Pin Hold Clip |
Install the clip.
Tech Tips
Use the same procedure for the RH side and LH side.
Install the front bumper assembly with the pin hold clip as shown in the illustration.
Note
Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.
Tech Tips
Use the same procedure for the RH side and LH side.
INSTALL COOL AIR INTAKE DUCT SEAL
Install the cool air intake duct seal with the 9 clips.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
PERFORM DIAGNOSTIC SYSTEM CHECK
ADD WINDSHIELD WASHER FLUID (w/ Headlight Cleaner System)