DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL V-RIBBED BELT


    1. B003UJIC01
      *1 Water Pump Assembly
      *2 Generator Assembly
      *3 No. 2 Idler Pulley Sub-assembly
      *4 V-ribbed Belt Tensioner Assembly
      *5 Crankshaft Pulley
      *6 Compressor and Magnetic Clutch Assembly

      Set the V-ribbed belt onto every pulley.

      Note


      • Put the backside of the V-ribbed belt on the V-ribbed belt tensioner pulley and No. 2 idler pulley sub-assembly.

      • Check that the V-ribbed belt is properly set to each pulley.

    2. While turning the V-ribbed belt tensioner assembly counterclockwise, remove the bar.

    3. B003SV9

      If it is difficult to install the V-ribbed belt, perform the following procedure.

    4. Check that the V-ribbed belt fits properly in the ribbed grooves.

      Tech Tips

      Make sure to check by hand that the V-ribbed belt has not slipped out of the grooves on the bottom of the crankshaft pulley.

  2. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here

  3. INSTALL INLET NO. 1 AIR CLEANER

    Click here

  4. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here