СТАРТЕР СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  4. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  5. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    1. A01QOIO

      Remove the bolt and loosen the nut.

    2. Detach the hook of the battery clamp sub-assembly from the front battery bracket, and then remove the battery clamp sub-assembly.

  8. REMOVE BATTERY

  9. REMOVE BATTERY TRAY

  10. DISCONNECT RADIATOR HOSE SUB-ASSEMBLY


    1. A01QRWI

      Remove the 2 bolts and disconnect the radiator hose sub-assembly from the front battery bracket.

  11. REMOVE FRONT BATTERY BRACKET


    1. A01QS5N

      Detach the 3 wire harness clamps.

    2. A01QRL2

      Remove the 4 bolts and front battery bracket.

  12. REMOVE BATTERY BRACKET REINFORCEMENT


    1. A01QTDC

      Remove the 2 bolts and battery bracket reinforcement.

  13. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (for CVT)


    1. A01QSZ8

      Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

  14. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET (for CVT)

    Click here

  15. REMOVE STARTER ASSEMBLY


    1. A01QUIX

      Disconnect the terminal cap.

    2. Remove the nut and disconnect the starter wire.

    3. Disconnect the starter connector.

    4. Remove the 2 bolts and starter assembly.

  16. REMOVE FLYWHEEL HOUSING SIDE COVER


    1. A01QU23

      Remove the flywheel housing side cover from the cylinder block.