ТРОС МЕХАНИЗМА ПЕРЕКЛЮЧЕНИЯ ПЕРЕДАЧ СНЯТИЕ

PROCEDURE

1. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

4. REMOVE NO. 2 CYLINDER HEAD COVER

   Click here

5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

   Click here

6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

   
   

   1. Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.

7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

   Click here

8. REMOVE BATTERY CLAMP SUB-ASSEMBLY

   Click here

9. REMOVE BATTERY

10. REMOVE BATTERY TRAY

11. DISCONNECT RADIATOR HOSE SUB-ASSEMBLY

    Click here

12. REMOVE FRONT BATTERY BRACKET

    Click here

13. REMOVE BATTERY BRACKET REINFORCEMENT

    Click here

14. REMOVE FRONT FLOOR COVER

    Click here

15. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

16. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    
    

    1. Move the shift lever to N.

    2. 

       Disconnect in this Direction

       Disconnect the end of the transmission control cable assembly from the shift lever assembly.

    3. 

       *1	Stopper
       *2	Nut
       	Turn in this Direction
       	Pull out in this Direction

       Pull out the stopper of the transmission control cable assembly.

    4. Turn the nut of the transmission control cable assembly counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever assembly.

       Note

       Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.

17. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

    
    

    1. 

       Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

    2. Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

    3. 

       Remove the nut and disconnect the transmission control cable assembly from the transmission control cable support.

    4. 

       Remove the bolt and disconnect the transmission control cable assembly from the rear engine mounting insulator.

    5. 

       Remove the 2 bolts and transmission control cable assembly.