ВПУСКНОЙ КОЛЛЕКТОР СНЯТИЕ

PROCEDURE


  1. REMOVE GENERATOR ASSEMBLY

    Click here

  2. REMOVE STARTER ASSEMBLY

    Click here

  3. REMOVE THROTTLE BODY ASSEMBLY

    Click here

  4. REMOVE VACUUM SENSOR ASSEMBLY

    A01GBJY

    1. Disconnect the vacuum sensor assembly connector.

    2. Remove the engine cover joint and vacuum sensor assembly.

    3. Disconnect the No. 1 air hose from the vacuum sensor assembly.

  5. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)

    A01GAER

    1. Disconnect the vacuum switching valve assembly connector.

    2. Disconnect the vacuum hose and No. 2 air hose.

    3. Remove the bolt and vacuum switching valve assembly.

  6. REMOVE INTAKE MANIFOLD


    1. A01GBSV

      Remove the bolt and wire harness clamp bracket.

    2. Detach the 4 clamps and wire harness from the intake manifold.

    3. A01GDGW

      Disconnect the fuel vapor feed hose from the intake manifold.

    4. Slide the clamp and disconnect the PCV hose from the intake manifold.

    5. A01GACS

      Remove the 5 bolts, 2 nuts, intake manifold stay and intake manifold.

    6. A01GAZZ

      Remove the gasket from the intake manifold.

    7. A01GAG2

      Remove the bolt and wire harness clamp bracket from the intake manifold.

    8. with Stud Bolt:

      Using an E6 "TORX" socket wrench, remove the 2 stud bolts from the intake manifold.

  7. REMOVE NO. 1 GAS FILTER

    A01GAI2

    1. Remove the No. 1 air hose from the No. 1 gas filter and intake manifold.

    2. Using a 24 mm deep socket wrench, remove the No. 1 gas filter from the intake manifold.

  8. REMOVE ENGINE COVER JOINT


    1. A01GBN4

      Remove the engine cover joint.