ТОПЛИВНАЯ ФОРСУНКА СНЯТИЕ

PROCEDURE

1. DISCHARGE FUEL SYSTEM PRESSURE

   Click here

2. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

   Click here

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. REMOVE NO. 2 CYLINDER HEAD COVER

   Click here

5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

   Click here

6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

   Click here

7. REMOVE BATTERY CLAMP SUB-ASSEMBLY

   Click here

8. REMOVE BATTERY

9. REMOVE BATTERY TRAY

10. DISCONNECT ENGINE WIRE

    Click here

11. REMOVE AIR TUBE

    Click here

12. REMOVE WIRE HARNESS CLAMP BRACKET

    
    

    1. 

       Remove the 2 nuts and wire harness clamp bracket.

13. DISCONNECT FUEL TUBE SUB-ASSEMBLY

    
    

    1. 

       Remove the No. 2 fuel pipe clamp and disconnect the fuel tube sub-assembly.

       Click here

14. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

    
    

    1. 

       Remove the bolt and wire harness bracket.

    2. 

       Remove the 2 bolts.

    3. 

       Remove the bolt and fuel delivery pipe sub-assembly.

       Note

       Be careful not to drop the fuel injectors when removing the fuel delivery pipe sub-assembly.

    4. 

       Remove the 2 No. 1 delivery pipe spacers.

15. REMOVE FUEL INJECTOR ASSEMBLY

    
    

    1. 

       Pull the 4 fuel injector assemblies out of the fuel delivery pipe sub-assembly.

    2. Remove the O-ring from the fuel injector assembly.

    3. 

       For reinstallation, attach a tag or label to the injector shaft.

       Note

       Prevent entry of foreign objects by covering the fuel injector assembly with plastic bags.

    4. Remove the 4 injector vibration insulators from the cylinder head.