ECM СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01V6PR

      Detach the wire harness clamp from the air cleaner case sub-assembly.

    2. Remove the 3 bolts and air cleaner case sub-assembly.

  6. REMOVE ECM


    1. Disconnect the 2 ECM connectors.

      Note

      After disconnecting a connector, make sure that dirt, water or other foreign matter does not contact the connector.


      1. A01V762C01
        *a Push
        *b Lock

        Move the 2 levers as shown in the illustration while pushing the locks on the 2 levers and disconnect the 2 ECM connectors.

    2. A01V8HI

      Remove the 3 bolts and ECM.

  7. REMOVE NO. 1 ECM BRACKET


    1. A01V9HO

      Remove the 2 screws and No. 1 ECM bracket.

  8. REMOVE NO. 2 ECM BRACKET


    1. A01VAQU

      Remove the 2 screws and No. 2 ECM bracket.