RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT LIGHT CUT RELAY (for LHD)


    1. Remove the fuse box opening cover.

      Click here

    2. A01V9A0

      Detach the clamp.

    3. A01V8SS

      Remove the light cut relay.

    4. A01V7M3N01

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the light cut relay.

    5. Install the light cut relay.

    6. Install the fuse box opening cover.

      Click here

  2. INSPECT LIGHT CUT RELAY (for RHD)


    1. Remove the combination meter assembly.

      Click here

    2. A01V9N7

      Remove the light cut relay.

    3. A01V7M3N01

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the light cut relay.

    4. Install the light cut relay.

    5. Install the combination meter assembly.

      Click here