IMMOBILISER SYSTEM(w/o Entry and Start System), Diagnostic DTC:B279C

DTC Code DTC Name
B279C Theft Deterrent System Presence Detection

DESCRIPTION

If an ECM that is incompatible with the immobiliser system is installed, the ECM stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B279C Theft Deterrent System Presence Detection An ECM that is incompatible with immobiliser system is installed. ECM

    DTC Output Confirmation Operation:

  • Check for DTCs.
Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
Engine cannot be started -
Related Data List and Active Test
DTC No. Data List and Active Test
B279C -

CAUTION / NOTICE / HINT

Note


  • If the ECM is replaced, refer to the Service Bulletin.

  • After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

  • When using the GTS with the vehicle ignition switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Immobiliser. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Powertrain > Engine and ECT > Clear DTCs
      Powertrain > Engine > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT

  2. CHECK FOR DTC


    1. Start the engine.

    2. Check for DTCs.

      Click here


      Powertrain > Engine and ECT > Trouble Codes
      Powertrain > Engine > Trouble Codes

      Tech Tips

      Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.

      Result
      Proceed to
      DTC B279C is not output
      DTC B279C is output (for 2AR-FE)
      DTC B279C is output (for 3ZR-FAE)
      DTC B279C is output (for 3ZR-FE)
      DTC B279C is output (for 1AD-FTV)
      DTC B279C is output (for 2AD-FTV)
      DTC B279C is output (for 2AD-FHV)

    DTC B279C is not output

    USE SIMULATION METHOD TO CHECK Click here

    DTC B279C is output (for 2AR-FE)

    REPLACE ECM Click here

    DTC B279C is output (for 3ZR-FAE)

    REPLACE ECM Click here

    DTC B279C is output (for 3ZR-FE)

    REPLACE ECM Click here

    DTC B279C is output (for 1AD-FTV)

    REPLACE ECM Click here

    DTC B279C is output (for 2AD-FTV)

    REPLACE ECM Click here

    DTC B279C is output (for 2AD-FHV)

    REPLACE ECM Click here