BRAKE ACTUATOR(w/ VSC) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. for 1AD-FTV:

      Click here

    2. for 2AD-FHV:

      Click here

    3. for 2AD-FTV

      Click here

    4. for 2AR-FE:

      Click here

    5. for 3ZR-FAE:

      Click here

    6. for 3ZR-FE:

      Click here

  4. DRAIN BRAKE FLUID

    Note

    Wash off brake fluid immediately if it comes in contact with any painted surface.

  5. DISCONNECT CONNECTOR


    1. A01KD2D

      Release the lock lever and disconnect the brake actuator connector.

      Note

      Be careful not to allow brake fluid to enter the removed connector.

  6. DISCONNECT BRAKE LINE


    1. A01KBTR

      Using a union nut wrench, disconnect the 6 brake lines from the brake actuator.

    2. A01KAPGE01

      Use tags or make a memo to identify the places to reconnect.

      Tech Tips


      • *1: to front wheel cylinder RH

      • *2: to front wheel cylinder LH

      • *3: to rear wheel cylinder RH

      • *4: to rear wheel cylinder LH

      • *5: from front master cylinder

      • *6: from rear master cylinder

  7. REMOVE BRAKE ACTUATOR WITH BRACKET


    1. A01KDHG

      Disconnect the brake tube clamp from the bracket.

    2. A01KDH0

      Remove the 3 nuts and actuator with bracket.

      Note

      Be careful not to damage the brake tubes.