TRANSFER CASE FRONT OIL SEAL(for RH Side) REPLACEMENT

PROCEDURE

1. DRAIN TRANSFER OIL

   Click here

2. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

   Click here

3. REMOVE MANIFOLD STAY (for 3ZR-FE, 3ZR-FAE)

   Click here

4. REMOVE DRIVE SHAFT BEARING BRACKET

   
   

   • for 2AD-FTV, 2AD-FHV: Click here

   • for 2AR-FE: Click here

   • for 3ZR-FE, 3ZR-FAE: Click here

5. REMOVE TRANSFER CASE OIL SEAL RH

   

   *1	Transfer Case Oil Seal RH

   
   

   1. Using SST, remove the transfer case oil seal RH from the No. 1 transfer case cover.

      SST

      09308-00010

      Note

      Do not scratch the press-fitting surface of the transfer case oil seal RH.

6. INSTALL TRANSFER CASE OIL SEAL RH

   

   *1	Transfer Case Oil Seal RH

   
   

   1. Using SST and a hammer, tap in a new transfer case oil seal RH as shown in the illustration.

      SST

      09316-60011   ( 09316-00011 )

      Drive in depth (A)
      7.5 to 8.5 mm (0.296 to 0.334 in.)

      Note

      
      

      • Tap the transfer case oil seal RH uniformly so that the transfer case oil seal RH is straight.

      • Do not tap the transfer case oil seal RH in too far.

7. INSTALL DRIVE SHAFT BEARING BRACKET

   
   

   • for 2AD-FTV, 2AD-FHV: Click here

   • for 2AR-FE: Click here

   • for 3ZR-FE, 3ZR-FAE: Click here

8. INSTALL MANIFOLD STAY (for 3ZR-FE, 3ZR-FAE)

   Click here

9. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

   Click here

10. ADD TRANSFER OIL

    Click here

11. INSPECT TRANSFER OIL LEAK