TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE


  1. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  5. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. REMOVE AIR CLEANER FILTER ELEMENT

  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  9. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  10. REMOVE BATTERY

  11. REMOVE BATTERY TRAY

  12. REMOVE FRONT BATTERY BRACKET

    Click here

  13. REMOVE BATTERY BRACKET REINFORCEMENT

    Click here

  14. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  15. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A01V8XF

      Disconnect the end of the transmission control cable assembly from the shift lever.

    3. A01V9G0C03
      *1 Stopper
      *2 Nut

      Pull out the stopper of the transmission control cable assembly.

    4. Rotate the nut of the transmission control cable counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever retainer.

      Note

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

    5. A01V97K

      Remove the nut and disconnect the control cable assembly from the control shaft lever.

    6. Remove the clip and disconnect the transmission control cable assembly from the control cable bracket.

    7. A01VAQZ

      Disconnect the transmission control cable assembly from the control cable support.

    8. A01V97B

      Remove the bolt and disconnect the clamp of the transmission control cable assembly.

    9. A01V9TN

      Remove the 2 nuts and disconnect the transmission control cable assembly.

    10. Pull out the transmission control cable assembly to remove it.