MANUAL TRANSAXLE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Note

When the transaxle is removed, be sure to use a new clutch release with bearing cylinder and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder to return to its original position, and dust could damage the seal of the clutch release with bearing cylinder, possibly causing clutch fluid leaks.

PROCEDURE


  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

    Click here

  2. REMOVE STARTER ASSEMBLY

    Click here

  3. REMOVE WIRE HARNESS CLAMP BRACKET


    1. A01VAV8

      Remove the bolt and engine wire from manual transaxle assembly.

    2. Disconnect the back-up light connector, 2 clamps and engine wire from the manual transaxle assembly.

    3. A01V9F3

      Remove the bolt and wire harness clamp bracket.

  4. REMOVE MANUAL TRANSAXLE ASSEMBLY


    1. A01V987

      Remove the 10 bolts and manual transaxle assembly.

  5. REMOVE FRONT ENGINE MOUNTING BRACKET


    1. A01VA3A

      Remove the 3 bolts and front engine mounting bracket.

  6. REMOVE ENGINE MOUNTING BRACKET LH


    1. A01V856

      Remove the 4 bolts and engine mounting bracket LH.

  7. REMOVE REAR ENGINE MOUNTING BRACKET


    1. A01V91M

      Remove the 4 bolts and rear engine mounting bracket.

  8. REMOVE CLUTCH ACCUMULATOR ASSEMBLY

    Click here

  9. REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY

    Click here

  10. REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY

    Click here

  11. REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY


    1. A01VALM

      Remove the bolt and speedometer driven hole cover sub-assembly from the manual transmission case.

    2. Remove the O-ring from the speedometer driven hole cover sub-assembly.

  12. REMOVE TRANSFER ASSEMBLY

    Click here

  13. REMOVE TRANSFER AND TRANSAXLE SETTING STUD BOLT



    1. A01VAXN

      Remove the 2 transfer and transaxle setting stud bolts.

      Tech Tips

      It is not necessary to remove the transfer and transaxle setting stud bolts unless they are being replaced.