AUTOMATIC TRANSAXLE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Note

If automatic transmission parts are replaced, refer to the Parts Replacement Compensation Table to determine if any additional operations are necessary.

Click here

PROCEDURE


  1. REMOVE DRIVE PLATE AND TORQUE CONVERTER ASSEMBLY SETTING BOLT


    1. A01QSQE

      Remove the flywheel housing under cover.

    2. A01QRW4N02

      Using SST, hold the crankshaft pulley.

      SST
      09213-54015
    3. A01QR65

      Remove the 6 drive plate and torque converter assembly setting bolts.

  2. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

    Click here

  3. REMOVE STARTER ASSEMBLY

    Click here

  4. DISCONNECT WIRE HARNESS


    1. Remove the bolt and disconnect the ground cable from the automatic transaxle assembly.

      A01QSBX

    2. Detach the 5 wire harness clamps.

    3. Turn the lock lever and disconnect the connector from the wiring harness connector.

    4. Disconnect the park/neutral position switch connector.

  5. REMOVE WIRE HARNESS CLAMP BRACKET


    1. Remove the 2 bolts and 2 wire harness clamp bracket.

      A01QQ4L

  6. REMOVE BREATHER HOSE BRACKET


    1. A01QS7D

      Detach the transmission breather hose sub-assembly from the breather hose bracket.

    2. A01QP6O

      Remove the bolt and breather hose bracket from the automatic transaxle assembly.

  7. REMOVE WIRING HARNESS CONNECTOR


    1. A01QS96

      Remove the 2 bolts and wiring harness connector from the automatic transaxle assembly.

  8. REMOVE TRANSMISSION OIL COOLER


    1. A01QU4D

      Slide the clips and disconnect the oil cooler inlet hose and oil cooler outlet hose from the automatic transaxle assembly.

    2. Remove the 2 bolts and transmission oil cooler from the front engine mounting bracket.

  9. REMOVE FRONT ENGINE MOUNTING BRACKET


    1. A01QTPK

      Remove the 4 bolts and front engine mounting bracket from the automatic transaxle assembly.

  10. REMOVE REAR ENGINE MOUNTING BRACKET


    1. A01QSC4

      Remove the 3 bolts and rear engine mounting bracket from the automatic transaxle assembly.

  11. REMOVE ENGINE MOUNTING BRACKET LH


    1. A01QRV7

      Remove the 4 bolts and engine mounting bracket LH from the automatic transaxle assembly.

  12. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET


    1. A01QRVP

      Remove the 2 bolts and No. 1 transmission control cable bracket from the automatic transaxle assembly.

  13. REMOVE TRANSMISSION CASE PLUG ASSEMBLY


    1. A01QO7H

      Remove the transmission case plug assembly from the automatic transaxle assembly.

    2. Remove the O-ring from the transmission case plug assembly.

  14. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY


    1. A01QR7U

      Remove the 9 bolts and automatic transaxle assembly.

      Note

      To prevent damage to the knock pins, do not pry between the automatic transaxle assembly and engine.

  15. REMOVE TORQUE CONVERTER ASSEMBLY


    1. Remove the torque converter assembly from the automatic transaxle assembly.

      Note

      Make sure to remove the torque converter assembly horizontally from the input shaft.

  16. INSPECT TORQUE CONVERTER ASSEMBLY

    Click here

  17. INSPECT DRIVE PLATE

    Click here