DESCRIPTION
When the ECM detects a cruise control switch signal, it sends it to the combination meter assembly through CAN communication. Then the cruise control indicator light turns on.
The cruise control indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.
PROCEDURE
PERFORM ACTIVE TEST USING GTS
Select the Active Test, use the GTS to generate a control command, and then check that the cruise control indicator light illuminates.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. Lamp Cruise | Cruise control indicator light | ON or OFF | - |
| Tester Display |
|---|
| Indicat. Lamp Cruise |
| Result | |||
|---|---|---|---|
|
| Cruise control indicator light does not turn ON/OFF |
|
GO TO METER / GAUGE SYSTEM Click here |
| Cruise control indicator light turns ON/OFF |
|
READ VALUE USING GTS
Check the Data List for proper functioning of the cruise control indicator light.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| CCS Indicator M-CPU | Cruise control indicator (Main CPU) | ON or OFF | ON: Cruise control switch on, cruise control indicator light on OFF: Cruise control switch on, cruise control indicator light off |
- |
| Tester Display |
|---|
| CCS Indicator M-CPU |
| OK |
|---|
| When the cruise control switch operation is performed, the result will be the same as above. |
| Result | |||
|---|---|---|---|
|
| OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here |
| NG |
|
REPLACE ECM for 1AD-FTV: Click here |